Connecting a DJI Osmo Mobile

If you haven’t setup your DJI Osmo Mobile before, refer to DJI to learn how to pair the gimbal to your phone. (https://www.youtube.com/watch?v=qs7V7Nsh-zo)

After setting it up the first time you are ready to connect the DJI Osmo Mobile to Switcher Studio.

Before we start make sure of two things:

1.) Bluetooth is enabled on your phone. To check this on your phone, slide up from the bottom of the screen to reveal the control center and make sure the bluetooth logo is highlighted blue, if it is not, tap the icon.

2.) The DJI Osmo Mobile app is closed. To check this, unlock your phone and double tap on the home button, scroll to the left, find the app and slide up to completely close out the app.

Now we are ready, start by docking your iPhone into the DJI Osmo Mobile and tighten down the back screw.

Once your iPhone is secure, turn on the Osmo Mobile on and the gimbal should straighten out showing it is ready.

Next launch Switcher on the iPhone set in the Osmo Mobile. In the upper right you will see an icon of three lines, tap on that icon.

Next on the list that appears tap on “DJI Osmo Mobile/ Galileo.

Wait a few seconds and your DJI Osmo Mobile will show up in the list. Tap the Osmo Mobile you wish to connect.

A blue checkmark will appear to the left of the Osmo Mobile you selected showing that is has been connected.

Tap the “Menu” button the upper left and then tap “Back” in the upper left on the next menu.

You are now ready to use your DJI Osmo Mobile with Switcher Studio. Connect the camera to your main Switcher device as you normally would. Now when you move that source to the “Preview” window in Switcher you can remotely Pan and Tilt using the DJI Osmo Mobile.